Finite element modeling for the progressive collapse analysis of steel stiffened-plate structures in fires
Introduction
Steel stiffened-plate panels are used in naval, offshore, mechanical and civil engineering structures as primary strength structures. They are rarely subjected to fire accidents, which may result in structural collapse leading to casualty or severe damages to asset and the environment.
Fire safety engineering is a key design consideration for structures on land and at sea [3,4]. In ships and offshore structures, hydrocarbon fires usually stem from oil and gas leaks with ignition [[4], [5], [6], [7], [8], [9], [10], [11], [12]]. The authors contributed to the fire-induced progressive collapse testing of full-scale steel stiffened-plate structures under lateral patch loading [1,2]. Many useful studies are found in the literature in association with the fire-induced progressive collapse analysis of land-based structures which are rather portal frames than plated structures [[13], [14], [15], [16], [17], [18], [19], [20], [21], [22], [23], [24], [25], [26], [27], [28], [29], [30]]. Lou et al. [13] performed fire tests on full-scale steel portal frames associated with progressive collapse. Passive fire protection (PFP) is recognised as an effective option to protect structures in fires [4,[31], [32], [33], [34], [35], [36], [37], [38], [39], [40],48,49]. Fire safety engineering requires quantification of how much PFP contributes to delaying the structural collapse so that a greater period of time can be attained in the process of escape and evacuation.
In the earlier articles [1,2], the authors obtained the test data on the progressive collapse of full-scale steel stiffened plate structures without or with PFP under lateral patch loading in fires. The present paper is a sequel to these earlier articles. In this paper, computational models were developed using transient thermal elastic-plastic large-deformation finite element method. The computational model to analyse heat transfer from ambient temperature to steel temperature was developed for steel plated structures without or with PFP. The computational model for the analysis of the fire-induced progressive collapse behaviour without or with PFP was formulated at the elevated temperature. The computational models were validated by a comparison with the test data.
Section snippets
Computational models
The procedure for the quantitative fire risk assessment and management of structures and infrastructures [4] requires the fire-induced progressive collapse analysis [41] for identifying the fire consequences. Key tasks to analyse the fire-induced progressive collapse behaviour are: heat transfer analysis to define temperature in steel transferred from ambient temperature elevated due to fire, and thermal elastic-plastic large-deformation analysis to identify the progressive collapse behaviour.
Application of the computational models to the tested structures
The computational models presented in section 2 were applied to the fire-induced progressive collapse testing on full-scale steel stiffened plate structures without or with PFP under lateral patch loading. In the testing, the horizontal type fire test furnace in the ICASS/KOSORI in Hadong, South Korea (www.icass.certer) was used, as shown in Fig. 7(a). Gas burners were used to increase the temperature inside the furnace. The loading actuators were used to apply external forces during fire
Computational results and discussion
Fig. 15 compares the temperature history of the tested structure without PFP, obtained from the test [1] and predicated using the LS-DYNA heat transfer analysis. The temperature of the structure calculated through heat transfer analysis is very well matched with the temperature measured in the test. After 2720 s the heat system was shut down in the test, but in the computational model, the temperature of the structure was continued to observe without reducing the heat loads. The temperature of
Concluding remarks
The objective of the present study was to establish a procedure for the nonlinear computations of the fire-induced progressive collapse behavior for steel stiffened-plate structures without or with passive fire protection (PFP). Nonlinear finite element method computational modelling techniques for both the heat transfer analysis and the thermal elastic-plastic large-deformation analysis were developed, and they were validated with a comparison with the experimental data which was obtained from
Declaration of competing interest
The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.
Acknowledgements
The present study was conducted at the Korea Ship and Offshore Research Institute (International Centre for Advanced Safety Studies) at Pusan National University in South Korea which has been a Lloyd's Register Foundation Research Centre of Excellence since 2008.
References (58)
- et al.
Fire tests on full-scale steel portal frames against progressive collapse
J. Constr. Steel Res.
(2018) - et al.
Progressive collapse analysis of composite steel frames subject to fire following earthquake
Fire Saf. J.
(2019) - et al.
Nonlinear analysis of the progressive collapse for two-dimensional steel frame under fire conditions
Materialstoday Proc.
(2018) - et al.
Progressive collapse analysis of 3D steel frames with concrete slabs exposed to localized fire
Eng. Struct.
(2017) Chapter Six – Fire-Induced Progressive Collapse Analysis of High-Rise Buildings, Progressive Collapse Analysis Structures: Numerical Codes and Applications
(2018)- et al.
Fires in storages of LFO: analysis of hazard of structural collapse of steel-aluminium containers
J. Hazard Mater.
(2016) - et al.
Progressive collapse analysis of steel structures under fire conditions
Eng. Struct.
(2012) - et al.
Fire-induced progressive collapse mechanisms of steel frames with partial infil walls
Structure
(2020) - et al.
Influence of masonry infill walls on fire-induced collapse mechanisms of steel frames
J. Constr. Steel Res.
(2019) - et al.
Collapse performance of composite steel frames
Eng. Struct.
(2019)
Probabilistic assessment of failure time in steel frame subjected to fire load under progressive collapse scenario
Eng. Fail. Anal.
Collapse behaviour of a fire engineering designed single-storey cold-framed steel building in severe fires
Thin-Walled Struct.
Quantitative evaluation of progressive collapse process of steel portal frames in fire
J. Constr. Steel Res.
Progressive collapse triggered by fire induced column loss: detrimental effect of thermal forces
Eng. Struct.
Disproportionate collapse of 3D steel-framed structures exposed to various compartmental fires
J. Constr. Steel Res.
Simulations on progressive collapse resistance of steel moment frames under localized fire
J. Constr. Steel Res.
Fire safety assessment and optimal design of passive fire protection for offshore structures
Reliab. Eng. Syst. Saf.
Design and testing of innovative materials for passive fire protection
Fire Saf. J.
Fire resistance of passive fire protection coatings after long-term weathering
Process Saf. Environ. Protect.
A risk-based method for determining passive fire protection adequacy
Fire Saf. J.
A study on methods for fire load application with passive fire protection effects
Ocean Eng.
A parametric study on the use of passive fire protection in FPSO topside module
Int. J. Naval Arch. Ocean Eng.
Material solutions for passive fire protection of buildings and structures and their performances testing
Procedia Eng.
A review of the applicability of the jet fire resistance test of passive fire protection materials to a range of release scenarios
Process Saf. Environ. Protect.
Fire induced progressive collapse of steel building structures: a review of the mechanisms
Eng. Struct.
Full-scale fire testing to collapse of steel stiffened plate structures under lateral patch loading (Part 1) – without passive fire protection
Ships Offshore Struct.
Full-scale fire testing to collapse of steel stiffened plate structures under lateral patch loading (Part 2) – with passive fire protection
Ships Offshore Struct.
Ultimate Limit State Analysis and Design of Plated Structures
Advanced Structural Safety Studies with Extreme Conditions and Accidents
Cited by (16)
Comparative study of nonlinear analysis on O-ring bracing performance under progressive collapse
2024, Journal of Constructional Steel ResearchProgressive collapse of steel structures exposed to fire: A critical review
2023, Journal of Constructional Steel ResearchCollapse mechanisms of multi-story steel-framed modular structures under fire scenarios
2022, Journal of Constructional Steel ResearchCitation Excerpt :Fire-induced collapse of structures may cause mass casualties and catastrophic damage to property, e.g., as in the collapse events of World Trade Center in New York in 2001, Windsor Tower Building in Madrid, Spain in 2005, Plasco Building in Tehran, Iran in 2017, and so on. To enhance the structural robustness and to better understand the structural mechanisms against fire-induced collapse, many experimental [1–3], numerical [4–9], and analytical [10–12] studies have been conducted in the last decade. Nevertheless, most of them focused on the conventional structures, while very few of them concentrated on the steel-framed modular structures.
Multi-scale numerical simulation analysis of CFST column-composite beam frame under a column-loss scenario
2022, Journal of Constructional Steel ResearchCitation Excerpt :Severe progressive collapse of Miami apartment building with 98 deaths in 2021 [1,2], as well as serious progressive collapses in history (e.g., Ronan Point in 1968, Alfred P. Murrah Building in 1995, WTC in 2001), has drawn the attention of engineers to consider the performance of structures against progressive collapse. Emergencies such as explosion [3,4], fire [5,6], impact [7,8], terrorist attack [9], natural hazards such as earthquake, hurricane, and tsunami [9], foundation settlement, renovation modification, overloading of floors, design or construction errors [10] may cause the failure of one or some key columns, beams, and joints in the structure. Subsequently, the structure will collapse disproportionately when the redistribution of forces and mutual tensile action of the remaining structure cannot resist the primary loads.